Poly Bushing kit front sub frame
Saab 9-5 (-2010)
09.02.2026These fitting instructions are to be used as a guide and in conjunction with workshop manual.
It is recommended that:
- wheel alignment to be checked and adjusted as required after any suspension work.
- all fasteners must be tensioned to manufacturers torque settings.
Contents:
6 x bushes
6 x stainless steel sleeves
6 x metal washers
Support the subframe, loosen one side of the subframe then remove the other sides mounting bolts, allow the subframe to lower on that side to allow access to the bush.
Remove the original mounting bush, keeping the original bolt to reuse.
The new polyurethane bush fits into the subframe from the top side, place the tapered end down into the hole pull the bush into the subframe.
Tip: apply some washing up liquid the outside of the bush, tilt the bush so it is at a slight angle with part of the lip is already in the hole to help it pop in
Coat the inside of the bushes with special grease and insert the stainless steel sleeve.
The new washer fits between the top face of the bush and the chassis, use the original bolt when refitting.
- All notes serve only as an example and do not replace the workshop instructions of the automobile manufacturers! All information is supplied without guarantee!
Additional information...
- Installation guide: Poly Bushing kit front sub frame
09.02.2026, 272 KBytesDownload now
-
1042069: Bushing, Suspension Front axle Subframe Kit