English | Deutsch ||
Delivery Destination:
|| Help

Comfort tailgate module - Volvo XC70III up to -MY2011, chassis -104553

Volvo XC70III -MY2011, chassis -104553

22.12.2021

For vehicles with hydraulic tailgate. With this upgrade the tailgate can be opened or closed with the push of a button at the remote control or the dahsboard switch. To activate the function push and hold the button. Due to the vehicle construction there is a 3 sec. closing delay.


Attention!!!
Do not remove the soft protective shell off the module!!!
The soft shell is designed to protect the unit from vibration.
WR = RED
WK = BLACK
WW = WHITE
WB = BLUE
WG = GRAY


Remove the close button.
Disconnect the button connector. 


Remove the lock cover.
Unscrew the two screws in the handle (T-20).
Remove the handle. 


Unscrew the two screws on both sides (T-20).
Remove panel.


Take off the main interior panel of the tailgate. It`s held by eight clips. If your vehicle is equipped with keyless drive then the inside of the panel will have a sensor/antenna. In this case you need to take extra care when disassembling so you don`t damage the wiring. 


Two wires connect to the lock.
WK connect to the terminal on lock.
WG connect to the terminal on lock.
Secure the wires using cable ties (included with the module) to existing car harness so that they will not fall out. The closer to the lock connector you secure the wires, less chance the wires will fall out from vibration.


Insert the connector into the lock.


Three wires to connect to the button.
WR connect to the terminal on the button
WB connect to the terminal on the button
WW connect to the terminal on the button
Secure the wires using cable ties (included with the module) to existing car harness so that they will not fall out. The closer to the button connector you secure the wires, less chance the wires will fall out from vibration.


Assemble everything back in reverse order.
The result is two connectors are threaded through the opening. One for the module and other for the button.


Connect the device and hide it in the opening.
Reconnect the button and put it back in place.

Module operation on vehicles equipped with hydraulic power tailgate.
Long press on remote or inside car will open the tailgate.
Short press on remote or inside car will close the tailgate.

Please note:
On your remote the button that unlocks the car and the button that opens the tailgate will make the tailgate close. This means that when the tailgate is open if you do a short press on unlock the car button the tailgate will close too. (You will hear a slight click in the tailgate lock).
Vehicles equiped with keyless entry: "grab the handle to unlock the car" is equal to "short press on unlock the car button on the remote" This is the way the vehicle is designed and nothing can be done about it. Just keep this in mind. 

  • All notes serve only as an example and do not replace the workshop instructions of the automobile manufacturers! All information is supplied without guarantee!

Additional information...