English | Deutsch ||
Delivery Destination:
|| Help

Comfort tailgate module - Volvo XC70III from 2011-, chassis 104554-

Volvo XC70III 2011-, chassis 104554-

22.12.2021

For vehicles with electromechanical tailgate. With this upgrade the tailgate can be opened or closed with the push of a button at the remote control or the dashboard switch. To activate the function push and hold the button. Due to the vehicle construction there is a 3 sec. closing delay.


Attention!!!
Do not remove the soft protective shell off the module!!!
The soft shell is designed to protect the unit from vibration.
WR = RED
WK = BLACK
WW = WHITE
WB = BLUE
WG = GARY


Remove the close button.
Disconnect the button connector.


Remove the lock cover.
Unscrew the two screws in the handle (T-20).
Remove the handle. 


Unscrew the two screws on both sides (T-20).
Remove panel.


Take off the main interior panel of the tailgate. It`s held by eight clips. If your vehicle is equipped with keyless drive then the inside of the panel will have a sensor/antenna. In this case you need to take extra care when disassembling so you don`t damage the wiring. 


Two wires connect to the lock.
WK connect to the terminal on lock.
WG connect to the terminal on lock.
Secure the wires using cable ties to existing car harness so that they will not fall out. The closer to the button connector you secure the wires, less chance the wires will fall out from vibration.


Three wires to connect to the button.
WW connect to the terminal on the button
WB connect to the terminal on the button
WR connect to the terminal on the button
Secure the wires using cable ties to existing car harness so that they will not fall out. The closer to the button connector you secure the wires, less chance the wires will fall out from vibration.


Assemble everything back in reverse order.


The result is two connectors are threaded through the opening. One for the module and other for the button.


Connect the device and hide it in the opening.
Reconnect the button and put it back in place.

Module operation on vehicles equipped with electric power tailgate.
Long press on remote or inside car will open the tailgate.
Long press on remote or inside car will close the tailgate.

Please note:
When closing the tailgate using your remote or inside buttons there is a three seconds delay before the module closes the tailgate.
This three seconds delay is needed in order to properly close the tailgate when in an instance the tailgate was fully open. So the tailgate first opens completely and then closes. You need to remember this when you have low clearance above the tailgate (example low ceiling in garage) and you had to stop the tailgate in not fully open position.

  • All notes serve only as an example and do not replace the workshop instructions of the automobile manufacturers! All information is supplied without guarantee!

Additional information...