English | Deutsch ||
Delivery Destination:
|| Help

Comfort tailgate module - Volvo XC60 -2017

Volvo XC60 (-17)

22.12.2021

For vehicles with hydraulic and electromechanical tailgate. With this upgrade the tailgate can be opened or closed with the push of a button at the remote control or the dashboard switch. To activate the function push and hold the button. Due to the vehicle construction there is a 3 sec. closing delay.


Attention!!!
Do not remove the soft protective shell off the module!!!
The soft shell is designed to protect the unit from vibration.
WR = RED
WK = BLACK
WW = WHITE
WB = BLUE
WG = GARY


Unscrew torx screws on both sides (T-20).
Remove panel.


Remove the lock cover.
Unscrew the two screws in the handle (T-20). Remove the handle.
Remove the ceiling light.
Disconnect connector. 


Remove the close button.
Disconnect the connector 


Remove panel
If your vehicle is equipped with keyless drive then the inside of the panel will have a sensor/antenna.
In this case you need to take extra care when disassembling so you don`t damage the wiring. 


Disconnect the door lock connector.


Two wires connect to the lock
WK connect to the terminal on lock
WG connect to the terminal on lock
Secure the wires using cable ties to existing car harness so that they will not fall out. The closer to the lock connector you secure the wires, less chance the wires will fall out from vibration.


Three wires to connect to the button.
WW connect to the terminal on the button.
WB connect to the terminal on the button.
WR connect to the terminal on the button.


Assemble everything back in reverse order.
Secure the wires using cable ties to existing car harness so that they will not fall out. The closer to the button connector you secure the wires, less chance the wires will fall out from vibration. 


The result is two connectors are threaded through the opening.
One for the module and other for the button.


Connect the device and hide it in the opening.
Reconnect the button and put it back in place.

Module operation on vehicles equipped with electric power tailgate.
Long press on remote or inside car will open the tailgate.
Long press on remote or inside car will close the tailgate. 

Please note:
When closing the tailgate using your remote or inside buttons there is a three seconds delay before the module closes the tailgate.
This three seconds delay is needed in order to properly close the tailgate when in an instance the tailgate was fully open. So the tailgate first opens completely and then closes. You need to remember this when you have low clearance above the tailgate (example low ceiling in garage) and you had to stop the tailgate in not fully open position.

  • All notes serve only as an example and do not replace the workshop instructions of the automobile manufacturers! All information is supplied without guarantee!

Additional information...