Adhesive insulation mat
Volvo P1800 (1962)
23.11.2021How to install adhesive insulation mats.
Material
Tools:
heat gun, ruler, marker, cutter, wallpaper roller
First measure the area that will be pasted.
Unroll the insulation material and measure it.
Attention! The room temperature should be at least 20 degrees Celsius to ensure full flexibility of the material.
Mark the measures.
Use a cutter and a ruler to cut along the marks.
Double check the size.
Use a heat gun to heat the material constantly up to about 50 degrees Celsius.
Remove the protection film only along the edge (parallel to the bows) at first. Fit the insulation exactly to the edge of the target area, then slowly remove the protection step by step and press the amt to the surface. Avoid air bubbles.
Use the wallpaper roller and press the insulation mat firmly to the surface. Pay special attention to the corners and edges.
Installation is finished.
- All notes serve only as an example and do not replace the workshop instructions of the automobile manufacturers! All information is supplied without guarantee!
Additional information...
- 1036233: Absorber Bonnet Firewall Door Interior