Strut brace
Volvo 200
24.02.2026Installation guide for the strut brace for the Volvo 200 series. This type is the same as the factory strut tower brace that was used since 1978 in the 242 GT.
Unscrew the rear nut of both strut bearings.
Pull the factory plugs off the firewall.
The plugs protect the factory threads from rust and prevent engine smell from getting into the cabin.
Attach the strut brace to the firewall with the enclosed screw and spacer.
Only tighten the screw two or three rotations into the firewall and attach the other end of the brace to the stud of the strut bearing.
Put the nut back on the strut bearing stud and tighten it. The end of the strut brace should not rest on the edge of the strut bearing.
Tighten the screws on the firewall.
Done!
- All notes serve only as an example and do not replace the workshop instructions of the automobile manufacturers! All information is supplied without guarantee!
Additional information...
- Installation guide: Strut brace
24.02.2026, 752 KBytesDownload now
-
1020874: Suspension cross brace Steel Kit